Preparing The Pressure Washer - Promate PW2700 Operator's Manual

Hand tighten the inlet nut.
3. Turn on water supply.
The pressure washer requires a
minimum of 20 PSI and a flow rate
of 5 GPM.
4. PREPARING THE
PRESSURE WASHER
The pressure washer is shipped with
shipping oil plug to prevent oil
leakage from the pump during
shipping. To replace the shipping
plug with the
(provided) perform the following:
Failure to remove shipping plug and
replace it with the dipstick/oil plug
will damage pressure pump. Failure
to add pump Breather Plug could
void warranty.
1. Using a wrench, remove shipping
plug from pressure pump. Discard
shipping plug.
2. Remove pump Breather plug from
parts bag and insert ii into pressure
pump.
3. Tighten pump Breather plug securely
Breather plug
by hand. DO NOT use wrench to
lighten. Using a wrench to lighten
pump Breather Plug could strip
threads.
4. Use the oil level glass window on the
side of the pump to ensure that
pump oil is at mid-point or above.
5. Add oil to pressure pump if level is
below the prescribed level. Use only
30-weight non-detergent oil.
4-1. Adding Engine Oil
1. Move the pressure washer OUTSIDE
and place on flat and level surface.
2. Remove the engine oil dipstick and
place funnel in the oil reservoir.
3. Pour the supplied engine oil (30
weight) until oil level reaches the
threads inside the oil reservoir.
4. Hand tighten the oil dipstick and
clean any spilled oil.
7