Promate PW2700 Operator's Manual page 16

Pressure Pump
1. Drain all water from pressure hose, coil and
store it in cradle of pressure washer
handle.
2. Drain all water from spray gun and spray
wand by holding spray gun in vertical
position with nozzle pointed downward.
Squeeze trigger to remove fluids from
spray gun and spray wand. Store in spray
gun/hose holder.
3. Store chemical hose, high pressure hose
and spray wand so they are protected from
damage, such as being run over.
It is RECOMMENDED that you follow these
steps to protect the internal seals of pressure
washer when storing unit for more than 30day
and/or when freezing temperatures are
expected.
1. Obtain a funnel, six ounces of RV antifreeze
and approximately 36 inches of Garden
hose with a male hose connector on one
end.
Use only RV antifreeze. Any other type of
antifreeze is corrosive and can damage
pressure pump.
2. Connect 36-inch length of Garden hose to
water inlet of pressure pump.
3. Add RV antifreeze using the funnel.
4. Make sure engine ON/OFF switches OFF.
Slowly pull engine starter cord several
times until antifreeze comes out of
pressure hose connection of pressure
pump.DO NOT start engine this time.
5. Remove hose to water inlet of pressure
pump.
Pressure Washer
1. Cover pressure washer with a suitable
cover that does not retain moisture such as
a plastic- or plastic-coated tarp.
2. Store pressure washer in a clean, dry area.
Certain storage covers can be flammable or
can melt in higher temperatures. Do not place
storage cover over pressure washer unit until
it has completely cooled.
Preparing for Use After Storage
1. Slowly pull the starter cord a few times to
clean oil from the cylinder or to eject any
antifreeze from the pump which were
added prior to storage.
2. Remove the spark plug from the cylinder.
Wipe oil from the spark plug and return it
to the cylinder and retighten.
3. Reconnect the spark plug wire.
16