Promate PW2700 Operator's Manual page 10


DO NOT run the pressure pump without
the water supply connected and turned
on.
 Damage to the pressure washer resulting
from failure to follow this Instruction WILL
void the warranty.
 ALWAYS wear approved safety glasses
when operating pressure washers. Spray
can splash back or propel objects,
including incorrectly attached accessories.
6-1. Using the Spray Gun
To engage the Trigger lock, pull the lock up
until it clicks into the slot.
To disengage the Trigger lock, push the lock
down and into its original position.
6-2. To Operate the Trigger
1. Squeeze the trigger to start water flow
through the nozzle.
2. Release the trigger to stop water flow.
6-3. Washing / Cleaning
1. Firmly grip Spray Gun with Bolt hands.
2. Point the nozzle to a safe direction and
squeeze the Spray trigger to allow the
pump top purge air impurities in the
system and then redirect the nozzle to the
working surface.
3. When finished, release the gun trigger to
stop water flow.
6-4. Usage Tips
• For most effective cleaning, keep spray
nozzle from 8 to 24 inches away from
cleaning surface.
• If you get spray nozzle too close,
especially using high pressure mode
being cleaned, you may damage
surface being cleaned.
• DO NOT get closer than 6 inches when
cleaning tires.
6-5. Pressure Adjustment
Increase distance: To vary the pressure
on the surface being cleaned, vary the
distance between spray wand and the
surface being cleaned.
Change pressure
Completely shut down Pressure Washer
and stop gasoline engine, Change Spray
Nozzle for desired pressure (see 3-5.
Selecting the Right Nozzle). Then,
restart the engine.
Adjust pump pressure regulator: The pump
wand nozzle:
10