Meaning Of Icons - Vortice Kit Vario CO2 Instruction Booklet

ENGLISH

Meaning of icons

Nota: When the sensor regulator is powered on, or after a reset, it will show the following on the display:
rC151 + icon : Sensor regulator indication SCO2-IAQ.
v X.X: Indication of the sensor regulator firmware version.
wAit: Indication that the sensor regulator is in the process of initialization. In models without display, the
initialization process is indicated by the lighting of the central part of the front.
Indicative values for temperature, relative humidity and CO2 will be displayed randomly and continu ously on the display
during operating mode.
ICON
3
On / off operating status (automatic fan control):
Off: Off (on / off relay contact open).
On: On (on / off relay contact closed).
When switching the operating state on / off, the corresponding indication is displayed for a
moment:
Remote stop:
Off: Remote stop disabled (contact open digital input).
Lit flashing: Remote stop activated (digital input contact closed).
On/off CO2 regulation output status:
Off: Output deactivated (air quality relay contact open).
On: Output activated (air quality relay contact closed).
Proportional < regulation output status: 0% (0)...100% (H1)
These digits indicate the percentage of air renewal required.
Its display can be disabled.
If the alarm is enabled and active, it is displayed at. In the event of an alarm, the flashing
of the display can beactivated.
Note: With regulator off, no alarm is indicated on the display.
In parameter mode it indicates the parameter number.
INDICATION
OFF On
0 50
AL
H1
33