Table of Contents
Advertisement
LIMITS OF THE DETECTION SYSTEMS
An alarm or fire detection system can be very useful for the timely warning of every dangerous events like
fire, robbery or a simple infringement; sometime it can automatically manages the events (diffusion of
messages for the evacuation, automatic extinguishing of fire, to interface with TVCC systems, block of the
doors or ways leading up, automatic alert to the authorities, etc.). In any case it can not assure a protection
against damages of the property or caused during a fire or theft.
Each system can not correctly functioning if it is not installed and maintained in accordance with the
instructions of the producer.
PRECAUTIONS
The system and all the components have to installed in environment with the following features:
Temperature: -5 °C - +40 °C.
o
Humidity: 10% - 93% (without condensate).
o
This system, like all the solid components, can be spoiled from induced electrostatic voltage: handle the
boards keeping them on the rim and avoid to touch the electrical components.
An exact earth connection ensure, in any case, a reduction of the sensitivity to the noises.
If You are not able to solve some problems regarding the installation, please contact the NOTIFIER
Technical Service.
A fire alarm system will not operate without any electrical power. If AC power fails, the system will operate
from standby batteries only for a specified time.
During the planning stage it is necessary to value the requested autonomy to measure the power supply and
batteries.
The batteries have to be verified with periodicity from specialized staff.
Before the removal or the insertion of each board it is necessary to disconnect AC power and batteries.
Remove all electronic assemblies prior to any service operations.
The control panel and all the connected devices (detectors, modules, etc) can be damaged if, with
connected AC power, a board is inserted/removed or the cables are connected.
Peripheral devices (detectors, etc.) that are not perfectly compatible with the control panel can cause
damages both to the control panel and to the functioning of the system; maybe in a not so opportune
moment.
It is essential to use only material that NOTIFIER assure to be compatible with the control panel.
In case of doubt please contact the NOTIFIER Technical Service . The primary cause of the malfunctioning
is an insufficient/inadequate maintenance.
It is important to take care of these aspects from the planning of the installation, this will facilitate and reduce
the future costs for the interventions.
RE-MIND: Do not try to install the control panel and the devices before the
reading of this manual.
AM-1000
AM1000_ind
Installation manual
Doc. M-145.1-AM1000-ENG Rev. A.2
INDEX
NOTIFIER ITALIA
Advertisement
Table of Contents
