Oster XPERT Series Instructions Manual page 21

4. Install the integrated threaded jar bottom and blade assembly onto the Blend-N-Go cup and/or mini jar.
(Fig. 30). NOTE: For proper installation onto blender motor base, make sure locking lever rotates past
the anti-rotation tabs on the cup. Locking lever should not be positioned on top of any of the tabs (Fig.
31). Make sure to tighten the gray threaded jar bottom onto the Blend-N-Go cup and/or mini jar as far as
possible, ensuring that it passes the last anti-rotation tab (Fig. 32).
5. Place Blend-N-Go cup and/or mini jar assembly onto blender base (Fig. 33). Hold Blend-N-Go cup and/or
mini jar in position while blending. Operate blender according to the instructions in this instruction manual.
Blend until desired consistency.
6. Remove cup/jar from base (Fig. 34).
7. Remove threaded jar bottom with sealing ring and blade.
8. Place lid on Blend-N-Go cup and/or mini jar and turn clockwise to tighten (Fig. 35).
Fig. 28
Fig. 27
Fig. 28
Fig. 27
Note: The Blend-N-Go cup and mini jar are not compatible with Brazil models
incorrect
incorrect
correct
Fig. 29 Fig. 30
incorrect
incorrect
correct
Fig. 29
Fig. 30
correct
Fig. 31 Fig. 32
correct
Fig. 32
Fig. 31
En g li sh -9
Fig. 33 Fig. 34 Fig. 35
Fig. 33 Fig. 34 Fig. 35