Oster XPERT Series Instructions Manual page 20

USING THE BLEND-N-GO CUP AND THE MINI JAR
(ONLY FOR MODELS WITH BLEND-N-GO CUP ACCESSORY
IMPORTANT NOTE: The Blend-N-Go cup and the mini jar are only compatible with the GRAY threaded
jar bottom with the locking lever and the GRAY locking sealing ring.
PLEASE MAKE SURE TO USE THE FOLLOWING PARTS FOR THE BLEND-N-GO CUP AND THE MINI
JAR:
Locking
Lever
Locking
Lever
Before washing, ensure the blender is off and unplugged. Wash all components except blender base with soapy
water, a soft sponge and a bottlebrush. Do not use abrasive cleansers or sponges for cleaning. Rinse well and
dry. Parts are also dishwasher safe.
Place desired ingredients into cup/jar according to the following order: Liquids, fresh ingredients, frozen fruit,
ice, yogurt and ice cream.
WARNING: DO NOT PROCESS HOT FOODS OR LIQUIDS IN THE BLEND-N-GO CUP OR IN THE MINI
JAR.
(Cut all firm fruits, vegetables, and other foods into pieces no larger than 1.25 cm (1/2-inch) by 5.0 cm (2 inches))
1. Place blade into gray threaded jar bottom (Fig. 27). CAUTION: Blades are sharp. Handle carefully.
2. Place locking sealing ring over blade assembly. Carefully press and tuck sealing ring into locking groove
(Fig. 28).
3. Ensure the locking sealing ring is fully and evenly tucked in place and holding the blade assembly to the
threaded jar bottom. For correct assembly see (Fig. 29).
AND/OR MINI JAR ACCESSORY)
Gray
correct
Gray
correct
E n g li sh - 8
Black
incorrect
Black
incorrect
Gray
correct
Black
incorrect