Features - Sony TRINITRON BVM-14M4DJ Operation Manual

Features

Picture
HR (High Resolution) Trinitron
HR Trinitron tube provides a high resolution picture.
Horizontal resolution is more than 800 TV lines at the
center of the picture.
Comb filter
When NTSC video signals are received, a comb filter
activates to make more accurate Y/C separation. This
contributes to less of a decrease in resolution, cross
color and cross luminance phenomena.
Beam current feedback circuit
The built-in beam current feedback circuit assures
stable white balance.
Four color system available
The monitor can display NTSC, PAL, SECAM and
2)
NTSC signals. The appropriate color system is
4.43
selected automatically.
Blue only mode
In the blue only mode, an apparent monochrome
display is obtained with all three cathodes driven with
a blue signal. This facilitates color saturation and
phase adjustments and observation of VCR noise.
.........................................................................................................................................................................................................
1) "Trinitron" is a registered trademark of Sony
Corporation.
2) The NTSC system refers to an NTSC color system in
4.43
which the subcarrier frequency is modified to 4.43MHz.
When an NTSC recorded video program is played back
with a Trident (PAL/SECAM/NTSC
NTSC signal is output.
4.43
2(E)
Input
1) picture tube COMPONENT SDI
SMPTE 259M/CCIR 656-III 4:2:2 serial digital signals
from Digital BETACAM VTRs can be input and
output through these connectors.
When you install a Sony Component SDI kit <Audio>
BKM-102 (not supplied), you can monitor the sound
from serial digital input signals with the picture.
Analog RGB/component input connectors
Analog RGB or component (Y, R-Y and B-Y) signals
from video equipment can be input through these
connectors.
Y/C input connectors
The video signal, split into the chrominance signal (C)
and the luminance signal (Y), can be input through this
connector, eliminating the interference between the
two signals, which tends to occur in a composite video
signal, ensuring video quality.
External sync input
When the EXT SYNC selector is in the on position,
the monitor can be operated on the sync signal
supplied from an external sync generator.
Automatic termination
(connector with
The input connector is terminated at 75 ohms inside
when no cable is connected to the loop-through output
connector. When a cable is connected to an output
connector, the 75-ohm termination is automatically
released.
3) SDI: Serial Digital Interface
4) The Sony Component SDI Kit BKM-101C (for video) is
) VTR, the
4.43
2/01-15_BVM-14M4DE 3-860-496-01 (1) (J/E)
3) input/output connectors
mark only)
built in this unit.
4)