Table of Contents
Advertisement
E Z C L E A N | C O M P R E S S E D A I R S U P P LY U N I T | O I/ E ZC L E A N - E N R E V. A
1
Health and Safety
Document symbols
Symbols that appear in this document are explained below:
WARNING
This symbol in conjunction with the signal word 'WARNING'
indicates a potentially dangerous situation. Failure to
observe this safety information may result in death or
severe injury.
CAUTION
This symbol in conjunction with the signal word 'CAUTION'
indicates a potentially dangerous situation. Failure to
observe this safety information may result in minor or
moderate injury. The symbol may also be used for property
damage warnings.
NOTICE
This symbol indicates operator tips, particularly useful
information or important information about the product or
its further uses. The signal word 'NOTICE' does not indicate
a dangerous or harmful situation.
Safety precautions
Be sure to read, understand and follow the instructions
contained within this manual before and during use of the
equipment. Failure to do so could result in bodily harm or
damage to the equipment.
WARNING
Installation, operation, maintenance and servicing must be
performed:
• by suitably trained personnel only
• in accordance with the information provided in
this manual
• in accordance with relevant local regulations
Potential safety hazards
Electrical – high voltage
The EZClean air compressor unit requires a 230 or 115 V AC
mains supply to operate. A mains isolation switch must be
fitted in the supply to the unit.
Compressed air supply
The EZClean system generates compressed air up to a pressure
of 3.5 bar(g)/(50.7 psi(g)) maximum:
• do not use compressed air for any other purpose than that
for which it is provided
• never direct a stream of compressed air towards your
body or the body of any other person
• when handling/connecting compressed air lines:
– the correct safety procedures must be observed
– suitable PPE must be worn (goggles/gloves/overalls)
Weight
The EZClean air compressor unit weighs approximately 10.3 kg
(22.6 lb). The unit must be lifted only using appropriate lifting
equipment/personnel and in accordance with relevant health
and safety procedures and requirements.
Safety standards
This product has been designed to satisfy the requirements of
IEC61010-1:2010 3
edition 'Safety Requirements for Electrical
rd
Equipment for Measurement, Control and Laboratory Use' and
complies with US NEC 500, NIST and OSHA.
Product symbols
Symbols that appear on this product are shown below:
Functional earth (ground) terminal.
Direct current supply only.
This symbol, when noted on a product, indicates a
potential hazard which could cause serious personal
injury and/or death. The user should reference this
instruction manual for operation and/or safety
information.
This symbol identifies a risk of chemical harm and
indicates that only individuals qualified and trained to
work with chemicals should handle chemicals or
perform maintenance on chemical delivery systems
associated with the equipment.
This symbol indicates the need for protective eye
wear.
This symbol indicates the need for protective hand
wear.
Recycle separately from general waste under the
WEEE directive.
3
Advertisement
Table of Contents
