Table of Contents
Advertisement
8
E Z C L E A N | C O M P R E S S E D A I R S U P P LY U N I T | O I/ E ZC L E A N - E N R E V. A
...3 Installation
Pole-mounting
This procedure is for pole-mounting using the optional pole-
mounting kit.
When choosing the mounting location, leave sufficient space in
front of the unit to open the door fully (280 mm [11.0 in]).
Dimensions in mm (in)
330
(13.0)
395
(15.5)
205
(8.1)
*Add 280 (11.0) when door open
Figure 4 Pole-mounting
Referring to Figure 4:
1 Fit the pole mounting plate
secure using the M6 screws
2 Position the compressor unit
using the U-bolt
and M8 nuts/washers
D
NOTICE
It is not usually necessary to fit a second pole mounting
plate (and U-bolt) to the bottom of the enclosure but, if
necessary, an additional kit is required.
A
to the compressor unit
C
(supplied).
B
on the pole and secure
(supplied).
E
50 (1.9) U-bolt
205 (8.1) + 25 (1.0)
42 (1.6) U-bolt
205 (8.1) + 21 (0.8)
420
(16.5)
B
and
Advertisement
Table of Contents
