Back Panel Features - KRK VXT Series User Manual

Back Panel Features

(B) HF ADJUSTMENT (VXT 6 and VXT 8 ONLY)
High Frequency Adjustment is through a rear panel mounted 3-position toggle switch.
Range of control is +1dB, Flat, or -1dB shelving above 2 kHz. Factory setting is flat
(toggle switch is in middle position). Room acoustics may dictate which type of adjustment
you need to make to retain the proper frequency response from the monitor.
(B) LF ADJUSTMENT (VXT 6 and VXT 8 ONLY)
This 3-way switch adjusts the low-frequency response of the monitors. Proximity to walls
can add undesirable low frequency content.
compensate for exaggerated low frequency response. Room acoustics may dictate which
type of adjustment you need to make to retain the proper frequency response from the
monitor.
(A) SYSTEM LEVEL ADJUST
Input sensitivity is adjusted (counterclock-
wise reduces sensitivity) through a rear
panel mounted trim control.
range is from -30dB to +6dB. Factory preset
gain is +6dB, which should suffice for most
conditions. Normally adjustments would
only be made if you're using your VXT
monitors in a surround system and you need
to balance levels or if your monitor-source is
too hot and not adjustable.
Adjust the LF Adjustment switch to
6
Adjustment