Stihl SE 33 Instruction Manual page 23

9 Using the wet/dry vacuum cleaner
► Put the top ini place and fasten the container
locks.
► Switch the wet/dry vacuum cleaner on.
► Hold the suction hose in one hand and pick
the material up either directly or via an
attached accessory.
9.2 Picking up Liquid
To pick up liquid primarily: Push the foam filter
over the motor housing.
► Switch off the wet/dry vacuum cleaner and pull
the mains plug out of the socket.
► Release the container locks.
► Remove the top part and turn it over.
► Remove the filter bag.
Removing the cartridge filter
1
► Rotate the wing screw (1) counterclockwise.
► Remove the cartridge filter (2).
Checking the float
3
► Swing the float back and forth.
The float (3) moves.
► If the float (3) does not moved: Clean float (3)
with a soft brush.
► If the float (3) still does not move: Do not use
the wet/dry vacuum cleaner. Consult a STIHL
dealer.
There is a fault in the float (3).
0458-889-9821-B
Placing the foam filter
► Push the foam filter element (5) over the motor
housing (4).
► Put the top ini place and fasten the container
locks.
► Switch the wet/dry vacuum cleaner on.
► Hold the suction hose in one hand and pick
the material up either directly or via an
attached accessory.
► If the suction power deteriorates noticeably:
Switch off the wet/dry vacuum cleaner, pull the
mains plug out of the socket and empty the
container.
2
9.3
1
► To clean carpeted floors, set the rocker switch
on the floor nozzle to position (1).
► To clean hard floors, set the rocker switch on
the floor nozzle to position (2).
9.4
The wet/dry vacuum cleaner can also be used to
blow off dirt and dust from hard to reach spots.
► Remove the suction hose from the suction
connector.
Using the Floor Nozzle
2
Blowing
2
1
English
4
5
23