Connecting Wires To Terminals - Kenwood KRC-508S Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
To car light control switch
Ignition key
switch
Car fuse box
(Main fuse)
Battery
+ –
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
Rear left output (White)
FM/AM antenna input
Rear right output (Red)
Power control wire (Blue/White)
P.CONT
ANT.
Motor antenna control wire (Blue)
CONT.
ILLUMI
Dimmer control wire (Orange / White)
(KRC-608 only)
ACC
Car fuse
box
Ground wire (Black) · (To car chassis)
— 28 —
Front left output (White)
Front right output (Red)
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear). For example, if you connect the + connector
of the left speaker to a front output terminal, do not connect
the - connector to a rear output terminal.
Fuse (10A)
KENWOOD disc
changer/DAB control input/
Display Data Output Jack
Outputs data representing the
unit's current state, causing it
to appear in the external
display.To connect to this jack,
a converting adapter (optional)
is necessary.(KRC-608 only)
NOTE
To connect the Disc changer or
DAB unit, consult each manual.
White/Black
To front left
speaker
+
FRONT • L
White
Gray/Black
To front right
speaker
+
FRONT • R
Gray
Green/Black
To rear left
speaker
REAR • L
Green
Purple/Black
To rear right
speaker
REAR • R
Purple