Charging Instruction - MODSTER SR80 PRO User Manual

Manual - SR80 Vector Pro

Charging Instruction

To charge your lithium battery, use a charger that is compatible with your battery. Charging
the lithium battery using a non-compatible charger (such as NiCd or NiMH rechargeable bat-
tery chargers) or other non-compatible lithium battery chargers may damage the battery or
cause a fire, causing damage to property and / or personal injury.
CAUTION: Be sure to ensure proper polarization before connecting.
Troubleshooting Guide
Problem
Boat does not respond
to throttle but to other
controls.
Reduced runtime or
boat underpowered.
Boat does not link to
transmitter after
binding.
www.modster.at
Possible Cause
Throttle servo travel is lower than
100%.
Throttle channel is reserved.
Boat battery level is low.
Boat battery is damaged.
Blocking or friction on shaft or
propeller.
Boat conditions may be too cold.
Battery capacity may be too low
for conditions.
Drive torque is too close.
Too little lubrication in shaft.
Something blocks the rudder or
the propeller.
Transmitter is too near to the boat
during linking process.
Boat or transmitter is too close to
a large metal object.
Boat or transmitter battery
charge is too low.
Transmitter is bound to another
boat.
ESC is switched off.
Solution
Make sure throttle servo travel
is 100% or more.
Reverse throttle channel.
Completely recharge battery.
Replace it & follow instructions.
Disassemble, lubricate and
correctly align parts.
Make sure the battery is warm.
Replace battery.
Loosen coupling at shaft and
move shaft a little bit.
Fully lubricate shaft.
Remove boat from the water
and obstacles.
Move powered transmitter a
few feet away, disconnect and
reconnect the battery.
Move boat or transmitter away
from the large metal object.
Replace or charge the battery.
Bind your boat again to the
transmitter.
Switch ESC on.
29