Hoist Assembly - Briggs & Stratton VH-300 Operating Instructions Manual

III. HOW TO ASSEMBLE YOUR HOIST
1. Unpack all parts of the hoist and lay them out on the ground.
MAJOR PARTS LIST
3-8ft. track sections with splice plate's attached
1-VH Peak assembly
1-VH Carriage Flap (Flap Assembled on Carriage)
1-Carriage with 1/2" bolt, washers and lock nut (Bolt Assembled on Carriage)
1-Steel base section with winch drum, brake, cable and drive belt
1-Brake release handle with hitch pin
1-Power Pack (engine bolted on motor base)
Note that the engine is shipped without gas or oil. Oil needs to be added in the
crank case and the gear reduction unit, please refer to the instruction manual for
the engine for oil type and quantity.
2. Prepare hoist assembly by standing base section on its side with Brake Drum UP
and Brake spring away from assembler.
3. Slide an 8-ft. track section onto the base section with rung short side facing
towards assembler and secure each leg with two 3/8" carriage bolts and lock nuts.
Figure 1
4