Advertisement
•
Simple relocation of the sensors or the station may correct an interference issue.
•
Windows can reflect the radio signal.
•
Metal will absorb the RF (radio frequency) signal.
•
Stucco held to the wall by a metal mesh will cause interference.
•
Transmitting antennas from: ham radios, emergency dispatch centers, airports, military
bases, etc. may cause interference.
•
Electrical wires, utilities, cables, etc. may create interference if too close.
CAN I CHANGE BATTERIES IN MY SENSORS WITHOUT LOSING DATA?
We designed this station for convenience, so that a simple change of batteries does not lose
data or require you to power down your station.
•
When Battery Indicator shows in the Outdoor Sensor area, replace batteries in your Outdoor
Sensor.
•
Then hold the +/OUT button for 3 seconds and your station will search for your sensor.
•
When changing the batteries in the color station, continue using the power cord. After
replacing the batteries, no other action is needed. The batteries in the station only maintain
time/date in the event of a power outage.
HOW DO I VIEW MY MIN/MAX READINGS?
The MIN/MAX readings are all time values from when the station was first powered on or last
reset.
1. Press the MEM button to view indoor & outdoor MAX records.
2. Press MEM again to view MIN records.
Reset Records:
1. Press the MEM button to view records.
2. Hold the MEM button to reset all Indoor and Outdoor records to current readings.
FACTORY RESET: HOW DO I FACTORY RESET MY STATION?
To factory reset your station press the RST button.
7 |
P a g e
Advertisement
