Light Safeguards - Hughes JVC Model 200 Service Manual

CAUTION!
lamp fan has stopped running. This fan protects the arc lamp from
overheating. Disconnecting power before the cooling fans have
stopped running can shorten Arc Lamp life.

Light Safeguards

Ultra Violet and Infrared Light
Eye and face protection from ultra violet light and infrared light in
accordance with the following conditions:
WARNING, BRIGHT LIGHT!!!
Never look directly at the Arc Lamp, the lighted Projection
Lens or into the lamp housing, from any distance, when the
projector is on. Direct exposure to light of this brightness can
cause severe eye injury.
Dangerous levels of ultraviolet and infrared radiation,
dangerous glare, very high temperatures (180°C to 300°C) and
high internal gas pressure are present at the Xenon Arc
Lamp. The lamp is contained in a protective reflector housing
module and should not be operated outside this housing or
outside of the projector. When replacement is needed, the arc
lamp must be replaced as an entire module, as shown in this
Model 200 Service Manual. Do not open the lamp housing or
attempt to replace the Arc Lamp inside its module! Do not
touch the Arc Lamp, or any connections, when the lamp is
ignited or is arcing. Any servicing of the Arc Lamp must
remain restricted to Hughes-JVC certified maintenance
personnel.
Model 200 Service Manual
Do not unplug the power cord until after the arc
1. X3 (up to 375 nanometers), ANSI approved, shade
goggles must be worn by anyone near the projector
when it is lit and the cover is off.
2. X5 (375 to 700 nanometers), ANSI approved, shade
goggles when actually working on the projector
near the arc lamp source.
Safety Information
vii