Chapter 4---Maintenance (Removal/Replacement)
4.2 Projector Covers
Interlock Switch.
Pull up immediately after
removing front or rear cover
to reapply power to Arc
Lamp cooling fans.
Figure 4-2 Rollbar Assembly.
4-4
Prior to removing either cover, review the chapter on Safety and
adhere to all warnings and cautions.
To remove the front or rear covers (refer to Figure 4-2):
1. Disconnect the projector power plug.
2. Loosen the two pozidrive spring screws at the front of
the front cover or the rear of the rear cover.
3. Tilt up the front or rear cover.
CAUTION!
up! The covers can fall from this tilted up position and possibly
damage projector components. Remove the cover and set it
aside when servicing the projector.
4. Release the two Latch Levers on the Rollbar assembly
that hold the cover in place. Place the ends of the
Latch Levers into the holding slots.
CAUTION!
rear cover, pull up the power interlock switch. This allows
power to be reapplied to the fans to cool the Arc Lamp.
Holding Slots
Latch Levers
Do not leave either cover tilted
Immediately after removing the front or
Model 200 Service Manual