Heat Safeguards - Hughes JVC Model 200 Service Manual

Safety Information
Installation Safeguards

Heat Safeguards

vi
WARNING!!!
Procedures in this service manual require
removing the projector's covers to access internal component to
remove, replace, service and adjust the projector. Only Hughes-
JVC Certified Technicians are qualified to perform these
procedures. Before removing or replacing any internal
components or subassemblies, verify that the circuit breaker on
the back panel is in the Off position and remove the power plug.
Any adjustments performed that require covers off and power on
should be performed with extreme care. Be especially aware of
all hazardous areas indicated by warning and caution labels.
CAUTION!!!
Do not use a forklift to lift the projector without
using a safe shipping pallet. Lifting the projector without
supporting the weight at the foot locations can cause severe
damage to the projector.
If there is any visible damage to the power cable, disconnect
power to the projector until the damaged cable is replaced. Install
the projector on a smooth, vibration-resistant level surface, or
ceiling mount, in an area free from dust and moisture. Do not
place the equipment in direct sunlight or near heat-radiating
appliances. Smoke, steam and exposure to direct sunlight could
adversely affect the internal components.
If mounting the projector, use hardware that can handle a
minimum of three (3) times the projector weight.
Fans and Ventilation: The projector has multiple fans to cool the
system. Do not block the intake or outflow of any fans. Heat is
emitted within the system and must be properly dissipated to keep
the system running correctly. Blocking air intake or exhaust ports
can lead to projector overheating. Do not enclose the unit in a
restricted space (refer to the physical access and thermal
clearance illustration guidelines).
Model 200 Service Manual