Zte ZXMW NR8120A Maintenance Manual page 35

Parameter
Start Time
End Time
b. Select an MP record, and click the LM button. The query result is displayed, see
Figure
Figure 3-8 CFM Function Result Pane - LM Button
For a description of the query result, refer to the following table.
Parameter
Valid Result
Source MP ID
Destination MP ID
Local Last Loss Rate of
Packet
Local Average Loss Rate
of Packet
Remote Last Loss Rate of
Packet
Remote Average Loss
Rate of Packet
Start Time
End Time
SJ-20150804150350-006|2015-09-17 (R1.0)
Description
Displays the starting time of the test.
Displays the ending time of the test.
3-8.
Description
1 indicates that the result is valid while 0 indicates that the result is
invalid. An invalid result indicates that unknown errors occur during the
calculation process, causing the result invalid. Normally, the displayed
query result is valid.
Displays the MP ID configured for the end where the LM transmit
function is initiated.
Displays the MP ID of the destination end of the test.
After the LM function is enabled, the system calculates the packet loss
rate every an interval that is set when the function is enabled. This
parameter indicates the packet loss rate within the last interval while
Local indicates that the packet loss rate is calculated in the direction
from the destination end to the local end.
Indicates the average value of the local packet loss rates within all the
intervals of the test.
After the LM function is enabled, the system calculates the packet loss
rate every an interval that is set when the function is enabled. This
parameter indicates the packet loss rate within the last interval while
Remote indicates that the packet loss rate is calculated in the direction
from the local end to the destination end.
Indicates the average value of the remote packet loss rates within all the
intervals of the test.
Displays the starting time of the test.
Displays the ending time of the test.
3-9
Chapter 3 Fault Locating Methods
ZTE Proprietary and Confidential