Zte ZXMW NR8120A Maintenance Manual page 33

Parameter
MD Name
MA Name
MPID Primary Key
Loopback
Repeat Count
Data Length
TimeOut Time
Transmit Type
Destination MAC
5. In the left navigation tree, select ETH > OAM_CFM > Link Trace. The Link Trace
pane is displayed on the right.
6. Set the parameters, and click the Apply button. The CFM link trace function is
enabled, see
Figure 3-6 CFM Link Trace Pane
For a description of the parameters, refer to the following table.
Parameter
MD Name
MA Name
MPID Primary Key
Link Trace
Destination MAC
SJ-20150804150350-006|2015-09-17 (R1.0)
Description
Select an MD name from the configured MD list.
Select an MA name from the configured MA list.
Sets the local MEP ID configured for the port.
Sets whether the function is enabled.
Sets the number of times that an LBM packet is sent by the local end.
Sets the length of a packet sent by the LB function.
Sets the timeout value for the remote end to send the LBR packet.
Sets the packet transmit type to be Unicast or Multicast.
Sets the MAC address of the remote end.
Figure 3-6.
Description
Select an MD name from the configured MD list.
Select an MA name from the configured MA list.
Sets the local MEP ID configured for the port.
Sets whether the function is enabled.
Sets the MAC address of the remote end.
3-7
Chapter 3 Fault Locating Methods
ZTE Proprietary and Confidential