Zte ZXMW NR8120A Maintenance Manual page 34

ZXMW NR8120A/8120D Maintenance Guide
Parameter
TTL
TimeOut Time
7. In the left navigation tree, select ETH > OAM_CFM > Operation Result Info. The
Operation Result Info pane is displayed on the right, including the functions of test,
LM, unidirectional DM, bidirectional DM, loopback test, and link trace.
For functions except unidirectional DM, the query result can be displayed until the
functions are implemented completely. Each query only displays the result of the latest
operation, and historical operation results will not be displayed.
a. Select an MP record, which records the CFM operations of the MP, and click the
TEST button. The query result is displayed, see
Figure 3-7 CFM Function Result Pane - TEST Button
For a description of the query result, refer to the following table.
Parameter
Valid Result
Source MP ID
Destination MAC
Bandwidth
Throughput
Number of Loss Packet
SJ-20150804150350-006|2015-09-17 (R1.0)
Description
Sets the TTL of an LT packet.
Sets the timeout value for the remote end to send the LBR packet.
Note:
Description
1 indicates that the result is valid while 0 indicates that the result is
invalid. An invalid result indicates that unknown errors occur during the
calculation process, causing the result invalid. Normally, the displayed
query result is valid.
Displays the MP ID configured for the end where the Test Transmission
function is initiated.
Displays the MAC address configured for the end where the Test
Reception function is initiated.
Obtained through the CFM protocol packet test.
Obtained through the CFM protocol packet test.
Displays the number of lost CFM protocol packets that are used for
the TEST function whose Operator Type is set to Test Transmission
or Test Reception.
Figure
3-8
ZTE Proprietary and Confidential
3-7.