Commissioning; Settings; Tool Holder, Attachments - Festool TPC 18/4 Original Instructions Manual

Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
7

Commissioning

CAUTION
Risk of injury
► Only assemble when the power tool is
switched off!
7.1 Belt clip [1-13]
The belt clip allows the power tool to be attach­
ed to work attire for brief periods. It can be at­
tached to the right or left of the power tool us­
ing a screw [3].
7.2 Fitting the auxiliary handle [5]
WARNING! Always use the auxiliary handle.
► Check that the auxiliary handle [5-1] is se­
curely in place.
7.3 Inserting the stop bar [6]
The drilling depth can be adjusted using the
stop bar [6-1].
7.4 Switching on/off [1-5]
Press = ON, release = OFF
The speed can be continuously adjusted,
relative to the pressure applied to the
on/off switch.
Set the rotational direction switch [1-10] to the
centre position to lock the on/off switch.
The LED light [1-4] lights up when the on/off
switch [1-5] is pressed, see section 8.4.
8

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
8.1 Changing direction of rotation [1-10]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8.2 Changing gear
The gear switch [1-9] can be used to switch the
gear unit when the power tool is switched off.
8.3 Adjusting the torque [1-12]
Screwdriving
Torque corresponding to setting at the thumb­
wheel [1-12]:
Position 1 = low torque
Position 13 = high torque
There is a signal when the set torque is
reached and the power tool switches off. The
power tool only starts up again if the on/off
switch [1-5] is released and pressed again.
Drilling
Marking shows the drill symbol
mum torque.
8.4 Adjust lighting [1-12]
Configure lighting at the thumbwheel [1-12].
Marking shows position 1 to 13 or drill sym­
bol . The LED light [1-4] automatically
switches on and off with the power tool. The
LED light has an afterglow for a short time after
the tool has been switched off.
Marking shows lighting duration on/
maximum torque. Briefly apply pressure
on the on/off switch [1-5] to permanently
switch the LED light on. After ten minutes, the
LED light automatically switches off.
Marking shows lighting duration off/
maximum torque. The LED light is perma­
nently switched off.
8.5 Impact drilling
Move the selector switch [1-8] to the hammer
symbol . Set the thumbwheel [1-12] to the
drill symbol .
8.6 Festool Work app
The power tool can be configured with the
Festool Work app.
The battery pack is connected via
Bluetooth ® , see the operating manual for
the battery pack.
9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
English
= maxi­
19