Table of Contents
Advertisement
Gas Fired Steam Tilting Kettles
Water Connection
On units equipped with an optional water fill valve connect a water line (minimum 1/4") to the valve with a 1/4" NPT female fitting.
Units with dual (hot and cold) valves must have the hot water line connected to side with the hot water valve (red) and cold water
line to the cold water valve (blue). Plastic or rubber hose is not recommended, as it may melt against the hot kettle side.
Electrical Connection
Do not connect the appliance to the electrical supply until after the gas connection has been made.
This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard
and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug. (120V units only).
1. 120 VAC - 60 Hz - Single Phase
Units with this electrical rating are factory supplied with a three-wire cord and three-prong plug which fits any standard
120V, three-prong grounded receptacle. A separate 15 amp supply is needed for each unit.
2. 208/240 VAC - 60 Hz - Single and Three Phase.
Units with this electrical rating are factory equipped with a transformer. To connect supply wires remove cover from
transformer box at right rear of unit. Route supply wires and ground wire through the hole in the cover with a strain
relief fitting. Connect wires to the primary transformer terminals as required by your power supply voltage. Connect
ground wire to ground lug. Replace cover. Three-phase units are wired as above, using only two supply wires. The
third supply wire is not connected and must be properly terminated.
3. 220 VAC - 50 Hz - Single Phase.
Units equipped with this voltage rating should be wired exactly as in (Step 2) above.
INSTALLATION & OPERATION MANUAL 10325 REV 1 (11/21)
WARNING
WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
I
NSTALLATION
7
PAGE
OF32
Advertisement
Table of Contents
