Bauer 2161CR-B Owner's Manual & Safety Instructions page 15

Sanding Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Wipe the work surface clean of all dirt and debris,
especially that of previous
coarser sanding sessions, which will scratch
the surface of a finer grit sanding session.
2. Attach the desired grit Sanding Disk
(sold separately) onto the Backing Pad.
3. Make sure that the Switch/Trigger is in the
off-position, then attach Battery Pack.
4. Press the back of the Switch Trigger down
and then push it forward to start the tool. To
turn the tool off, release the Switch Trigger.
5. To lock the tool in the on position, press the
back of the Switch Trigger down and then
push it forward. Then press the front end
of the Switch Trigger down. To release the
lock, press the back of the Switch Trigger.
Item 58308 For technical questions, please call 1-888-866-5797.
6. Allow the tool to come up to full speed
before touching the work material ,
then gently contact the surface.
7. Keep heavy pressure off of the tool when operating.
Allow the tool to do the work.
8. Move the tool in a uniform pattern up and down or
side to side while sanding to ensure even sanding.
9. Periodically, stop the tool and check for disc wear.
Replace worn sanding discs as needed.
10. TO PREVENT ACCIDENTS, AFTER USE:
Turn off the tool.
WARNING! TO PREVENT SERIOUS INJURY:
Allow the tool to come to a complete stop
before setting it down.
Remove Battery Pack. Clean, then store
the tool indoors out of children's reach.
Page 15