Bauer 2161CR-B Owner's Manual & Safety Instructions page 12

Installing Wheel Guard
TO PREVENT SERIOUS INJURY: Do not operate this tool without the Wheel Guard properly installed.
Note: Grinding Wheel sold separately.
Note: Make sure Battery Pack is removed and tool
is off before installing Wheel or Wheel Guard.
1. Depress the Spindle Lock Button and rotate
the Clamp Nut until the Spindle Locks.
2. Loosen and remove Clamp Nut from
the Spindle. Remove Disc Flange.
3. Install Wheel Guard over the Spindle.
4. Rotate the Wheel Guard as needed to
shield you during the planned work.
Installing Side Handle
TO PREVENT SERIOUS INJURY:
Do not operate this tool with one hand only or without the Auxiliary Handle properly installed.
1. The Side Handle can be installed on
the left, or right side of the grinder,
depending on operator preference.
2. Insert the Side Handle into the
desired operating position.
3. Turn the side handle clockwise to securely tighten.
Page 12 For technical questions, please call 1-888-866-5797.
5. Replace Disc Flange. Make sure the flats on
bottom of the Disc Flange are engaged with
the depressed center of the Wheel Guard.
6. Check the Wheel Guard to ensure
it is firmly in place. Adjust if
necessary before proceeding.
Disc Flange
Wheel Guard
Spindle
Spindle Lock
Button
Figure A: Guard Installation
4. Reposition Wheel Guard if necessary. Wheel Guard
should be installed opposite the Side Handle.
a. Make sure Battery Pack has been
removed and tool is off.
b. Unlock Guard Clasp by pulling
Clasp out (away from Grinder).
c. Rotate Guard to correct position.
d. Relock the Guard Clasp by pushing Clasp in.
Note: Raised ridge on Wheel Guard should be
seated in the groove on the Bearing Cap.
Item 58308