Cleaning And Maintenance - Saturn ST-EK8036 Manual

2. Cup switch
Push up the cup switch to dispense hot
water.
NOTE: The hot water may not be able to
dispense out smoothly
boiling.
CAUTION:
1. Always keep the lid away from
you as hot steam may trap under the
lid.
2. Do not press the "DISPENSE"
button when the water tank is empty.
3. Hot water cannot be dispensed
by pressing the "DISPENSE" button and
cup switch if the appliance is unplugged.
To refill water
When the water level drops to the
"REFILL" line, add water for automatic
boiling. Refer
indicator for the marking.
Boiling water below the "REFILL" line
may cause malfunction to the appliance.
To reboil water under keep warm
mode
1. Reboil a full tank of water will
take about 3 minutes.
2. Before re-boiling, make sure
the water level is above the "REFILL"
line. Refer to the water level indicator
for the marking.
3. The "REBOIL" button may not
function right after the water has boiled.
4. When adding
water tank, be careful of the hot steam
while opening the lid.
5. Once the "REBOIL" button is
pressed, the boiling process cannot be
reset until the appliance automatically
switches to the "KEEP WARM" mode.
right
to the water
water to
6.
button repeatedly, as the continuous re-
boiling process will cause malfunction to
the appliance.
after When not in use
When the appliance is not in use, unplug
and remove the remaining water from
the water tank.
1.
out the remaining hot water slowly from
the water tank.
2.
thoroughly.
3.
dishwasher or dish dryer as this will
cause damage to the appliance.
4.
bag to protect it from dust and insects.
AUTO-CUT OFF FUNCTION
level 1.
appliance will automatically cut off the
power.
2.
also operate when:
•
no water inside the water tank.
•
"REFILL" line. Refer to the water level
indicator for the marking.

CLEANING AND MAINTENANCE

1.
cool down before cleaning.
2.
receptacle from the product body.
3.
remaining water.
4.
to accumulate, loud noises may be
heard during boiling and you may face
difficulties
Regular
problems.
MAINTENANCE OF THE WATER
TANK
Discoloration of the water tank and
white
water.
Red rust-like spots, milky or black
discoloration on the water tank, and
white floating objects are caused by
minerals in the water and are not cause
by discoloration or deterioration of the
water tank itself.
Although this is not a hygiene problem,
it is advisable to clean the inner of the
water tank periodically.
the
1.
brought citric acid into the water tank.
Add water until the water level reaches
full line marking. Close the lid.
NOTE: Do not fill the water more than
the full line marking. Please refer to the
6
Do not press the "REBOIL"
Press the manual pump to pour
Allow the appliance
Do not place the appliance in a
If not in use, seal in a plastic
When the water boil-dry, the
The auto cut-off function will
The power is switched on, but
Water level is
Always allow the appliance to
Remember to
Detach the lid and pour out
If mineral deposits are allowed
in dispensing
cleaning will
particles floating
Insert about 15-20g of store
to dry
below the
unplug the
hot water.
avoid such
in the