Daily Use - Washing & Drying - Electrolux EW2W3068E3 User Manual

28 www.electrolux.com
13. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
13.1 Non-Stop programme
1. Press On/Off for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
13.2 Washing & Automatic
drying
1. Press
display shows one of the dryness
level indicator:
• : IRON DRY level indicator for
cotton items
• : CUPBOARD DRY level
indicator for cotton, synthetic,
wool and silk items
• : EXTRA DRY level indicator
for cotton items
The display shows the indicator
time value on the display is the duration
of the washing + drying cycles,
calculated on a default load size.
To have a good drying the
appliance does not let you
set a too low spin speed for
the items to be washed and
dried.
again and again until the
2. Press
In the display the indicator of the set
dryness level stays on.
The door locked indicator
The display shows regularly a new time
value.
The last minutes of the
drying cycle the appliance
performs the anti-crease and
the cooling phases.
13.3 Washing & Timed Drying
To have a good drying the appliance
does not let you set a too low spin speed
for the items to be washed and dried.
1. Press
The display shows 10 minutes.
The indicator
The display shows the set drying value
time. for example:
seconds the display shows the final time
value
the washing and drying cycles (washing
+ drying + anti-crease + cooling phases).
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease
and the cooling phases.
2. Press
In the display the indicator
on. The door is locked. The display
shows regularly a new time value.
13.4 End of the programme
The appliance stops automatically. The
acoustic signals operate (if they are
. The
active).
For more information see "At the end of
the drying programme " of the previous
chapter.
1. Remove the laundry from the
appliance.
Make sure that the drum is empty.
2. Keep the door ajar to prevent mildew
and odours.
3. Close the water tap.
to start the programme.
goes on.
to set the drying time value.
comes on in the display.
. After some
, that is the total duration of
to start the programme.
comes