Daily Use - Washing & Drying - Electrolux EW7WB764T4 User Manual

11.13 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The time area shows
display shows the door locked
• The indicator of the Start/Pause
starts flashing.
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed by the
appliance.
2. Press the Start/Pause
appliance drains the water and spins.
The option indicator Rinse Hold
disappears.
If you have selected No Spin
appliance will only drain the water.
3. When the programme is completed and
the door locked indicator
you can open the door.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an automatic washer
dryer.
36 ENGLISH
4. Press the On/Off button for a few
11.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
and the energy consumption when:
.
• You do not use the appliance for 5
button
• 5 minutes after the end of the washing
button: the
If the dial is rotated to the "Reset" position
the appliance automatically turns off in 30
seconds.
If you set a programme or an option that
ends with water in the drum, the Stand-
, the
by function doesn't deactivate the
appliance to remind you to drain the
water.
goes off,
12.1 Complete wash&dry
programme
Automatic Non-Stop programme or
programmes
Depending on the model, the appliance may
be equipped with one or more One GO 1h
1kg programmes, automatic one-go
programmes where it is not necessary to set
the Mode - Dry.
Proceed as follows:
1. After loading laundry and detergent,
seconds to deactivate the appliance.
minutes when no programme is running.
Press the button On/Off to activate the
appliance again.
programme.
Press the On/Off button to activate the
appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
press the On/Off button for some seconds
to activate the appliance.
,