Siemens SICAM Q80 Operating Instruction page 32

E-32 SICAM Q80 7KG8080
If no status indicators are displayed, no connection could be made to the corresponding device.
The following symbols for the individual firmware components appear in the list:
not current
firmware conforms to current standards
error occurred during update procedure
this option is not available on the device
Select the device to be updated and then the softkey Update.
During the update, which can last up to several minutes, a progress indicator appears.
Do not switch off the device during the firmware-setup!
If an error message is posted during the firmware setup, leave the device on and contact the SIEMENS-Hotline. It
may possible to continue the firmware-setup under the guidance of the Hotline using the following service program.
A message box will appear to notify you if and when the firmware-setup has been completed successfully.
The File menu offers a function for working with the log-book.
Each action during the firmware setup and errors (if occurring) are registered in a log book. This log book can be
displayed with menu command File
10.4.6 Continuing the configuration
Once the interface has been configured successfully, the program attempts to set up a connection with the device and
to determine the device's hardware configuration. This process can last a few minutes.
Note
Power Quality Recorder SICAM Q80 7KG8080, Operating instruction
E50417-B1074-C419-A2, Release 12.01.2015
Show log book...
The Options menu offers the option to Update all components. This makes it possible
to earmark all the components of the selected device for an update. The function is
only to be used in compliance with instructions from the SICAM Q80 7KG8080-Hotline.
If the PC is unable to connect with the device, switch the device off for about 10 seconds. Then
it should work without further problems.