Siemens SICAM Q80 Operating Instruction page 31

10.4.5 Firmware Update
Each software version includes the most current SICAM Q80 7KG8080 firmware. This makes it easy to update the
system with new functions, for example. Depending on the particular device model, the following components are
automatically loaded: Interface-Firmware (Ethernet, Modem, ...), Boot-program, amplifier firmware, firmware for the
DSPs.
The firmware-update is only necessary if the SICAM Q80 Manager software was delivered as an update. If you
received your SICAM Q80 7KG8080 device together with the software, no firmware-update is required.
Once the program connects up with SICAM Q80 7KG8080, the device's firmware is checked. If the software version
doesn't match the device's firmware version, you are asked if you want to perform a firmware-update.
Note
The dialog for the firmware-update looks like this:
Interface
Booter
Operating system
Online
Field bus
Signal conditioners
As a matter of principle, we recommend updating to a higher version.
Downgrading to an older version can lead impairment of the device's functioning and to
increased occurrence of errors.
Ensure that the cable connection to the device is secure.
With a laptop running on its rechargeable battery, the battery must supply the computer
reliably. Switch the energy saving mode off, since under some circumstances it may switch
the laptop's network card off.
The status of the individual firmware components is displayed in the list.
Interface-Firmware (Ethernet)
Start-up program for the device upon switching-on
Device operating system
Online-functions and hard drive controller
Field bus (optional, if your device is equipped with CAN or J1587)
Amplifiers
Assembly, Commissioning, Parameterization
Power Quality Recorder SICAM Q80 7KG8080, Operating instruction
E50417-B1074-C419-A2, Release 12.01.2015
E-31