Table of Contents
Advertisement
"System" menu
Display
When operating the device, the
display (20) lights up to the value set
under "Bright." and dims back to the
value set under "Fade" after a few
seconds.
• Fade - Fade Display Content
Possible settings: Off, 10–100%
This value cannot be higher than the
value for "Bright".
• Bright.- Display Brightness
Possible values: 10–100%
Timer – Set Standby Timer
After a certain configurable period
of inactivity, the Cinebar Ultima will
automatically switch to standby.
Possible values: None (no automatic
deactivation), 15 m, 20 min, 30 min,
45 min , 60 min, 120 min.
De/Eng - Language Selection
Select the language for the display
panel.
Possible values: Deutsch, English
24
• Cinebar Ultima
Advanc. – Advanced System
Settings
• S-TV - Set Source for TV Sound
If your TV set does not emit the
television audio via HDMI ARC, you
can select another audio input here.
If you then select "TV" as source,
the Cinebar Ultima will switch to this
input:
TV-ARC – normal input for ARC
capable TV sets. PCM Stereo, Dolby
Audio and DTS (if this can be output
by the TV set) possible.
Optical – for TV sets with an optical
or coaxial-digital output. PCM, Dolby
Audio or DTS possible.
AUX– for TV sets with an analogue
audio output or headphone jack. Only
analogue signal possible, with or
without Dolby Pro Logic II.
• LipSync – To synchronize audio
and visual content
Digital image processing in the
television set requires some time. To
ensure that the picture and sound
stay in sync, you can configure an
audio delay here between 0 and
100 ms.
Advertisement
Table of Contents
