____________________________________________________________________
The following procedure assumes the correct configuration data files have been loaded and the
G1000 is in normal operating mode.
1. On the PFD press the following softkey sequence: 11, 11, 1, 1, 2.
2. The Radar Trim window will now appear (see Figure 7-7).
3. Use the FMS knob to highlight and adjust the pitch and roll trim. Pitch and roll trim can
be adjusted in 0.05° degree increments, between ± 4.00°. As you change a value the
window will display 'Configuring GWX' then 'GWX Configured'. The resulting radar
returns can be viewed on the MFD.
4. Use the FMS knob to highlight 'SAVE?' and press the ENT key. The GWX 68 will now
restart.
Page 7-34
Rev. A
G1000 System Maintenance Manual
190-00903-00