Garmin G1000 Maintenance Manual page 115

____________________________________________________________________
Symptom
SD card is stuck in GDU
A button/knob/joystick does not
appear to function
Terrain/Obstacle/Safetaxi does
not display
G1000 System Maintenance Manual
190-00903-00
Recommended Actions
•
DO NOT insert a screwdriver of any length into the card slot.
•
DO NOT pry against the overlay.
•
DO NOT force the SD Card out.
•
Use a small screwdriver in the groove on the side of the
exposed end of the card to help pull out the card. You may
need to push the card in further to release the card locking
mechanism.
•
If card was inserted with the label facing to the right, do not
attempt to remove. Return the unit to Garmin for repair.
•
If the card can be removed, check the card for having more
than one label. Two or more labels on the card will cause
sticking. Remove all but one label.
•
Ensure the SD card is from SanDisk. Use of other SD Cards is
not recommended.
Go to the GDU TEST page in configuration mode and verify button,
knob, or joystick operates correctly by observing a change in color
from red to green in the button/knob/joystick icon when the
button/knob/joystick is pressed. If a button is stuck, the button icon
will be green without pressing the button as soon as you turn to the
GDU TEST page. If problem is verified, replace GDU.
a. Ensure supplemental data cards are inserted correctly in the
lower slots of all three GDU's.
b. Allow the system to verify the data on the cards for
approximately five minutes after power-up.
c. If a database does not activate, reload the problem database
onto the SD Card or replace the card. You may need to
replace all datacards as a set to keep the database cycles the
same and prevent database mismatch errors.
Page 5-69
Rev. A