Honeywell Home RTH2510 Quick Installation Manual page 6

Quick Installation Guide
4
Mount New Wallplate
1. Loosen the locking screw at the bottom of the
thermostat. Note that the screw is captive and cannot
be removed from the wallplate.
2. Separate the thermostat from the wallplate as per
Figure 1.
3. Position the wallplate against the wall and mark hole
positions with a pencil.
NOTE: Levelling is for esthetics only and will not affect
the performance of the thermostat.
4. Drill holes at the marked positions and insert supplied
wall anchors.
5. Pass the wires through the large opening located at the
bottom center of the wallplate as per Figure 2.
6. Secure the wallplate to the wall with supplied mounting
screws as per Figure 3.
7. Connect the wires to the terminals.
Figure 1
69-2421ES—05
Figure 2
4
M38857
Figure 3