Table of Contents
Advertisement
8.2.1.1.
8.2.1.2.
8.2.1.3.
Copyright © 2020
Page | 31
Receiver Dryer Assembly
The receiver dryer assembly can, over time, become damaged. The component can
also become contaminated due to damaged, opened, cracked, or ruptured lines or
hoses. If the receiver dryer shows signs of damage, it should be removed and
replaced. If the receiver dryer has been contaminated, it must be removed and
replaced (refer to Disassembly, Section 5 and Assembly, Section 9). Contact Enviro
Systems customer service to order a new receiver dryer
Fan / Outlet Shroud
The fan / outlet shrouds can, over time, show signs of cracking and separation
between the shrouds and the condenser. This can cause the condenser module
assembly to have less than optimal performance. If the shrouds are separating, refer
to Disassembly Section for removal. Then refer to Cleaning Section. After insuring
that the seam between the shrouds and condenser have been cleaned according to
the cleaning procedures, apply a new bead of RTV6708 and reinstall shrouds. Allow
RTV to cure for a minimum of 24 hours before operating system. If the shrouds are
cracked or are damaged in any other way, they should be replaced.
Condenser Coil
The condenser coil fins can, over time, become clogged with dirt, dust, and other
foreign matter. The component can also become damaged. The coil return bends
can, over time, become damaged. Dents, nicks, cracks, and other damage can cause
less than optimal performance. It is essential that the condenser coil remain clear and
undamaged for proper operation. Refer to Cleaning Section for proper cleaning
procedures. If coil fins are bent, use a fin comb and try straightening the fins. If fins
are excessively damaged or the return bends are excessively damaged, the
condenser coil will require replacement.
Original Release
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
www.enviro-ok.com
passenger
www.safran‐
ATA 21‐00‐60
‐solutions.com
Advertisement
Table of Contents
