Table of Contents
Advertisement
8. REPAIR PROCEDURES
8.1. General:
8.1.1. Refer to Illustrated Parts Listing (IPL) for figure/item numbers.
8.1.2. The condenser fan and compressor assembly do not contain any field replaceable
components, therefore repair procedures are not provided for these assemblies.
WARNING: SERVICE TECHNICIANS ARE ADVISED TO OBSERVE STANDARD SAFETY
PRECAUTIONS, SUCH AS WEARING PERSONAL SAFETY GEAR, TO PREVENT INJURY WHILE
PERFORMING SERVICE TO THE UNIT.
CAUTION: SERVICE TECHNICIANS MUST PREVENT CONTAMINATION OF INTERNAL SYSTEM
PLUMBING DURING ANY SERVICING AND/OR MAINTENANCE OPERATION. THIS INCLUDES NOT
ALLOWING THE RECEIVER DRYER TO BE EXPOSED TO ATMOSPHERIC CONDITIONS FOR ANY
LENGTH OF TIME. ALL PLUMBING LINES SHOULD REMAIN CAPPED WHENEVER POSSIBLE DURING
THE SERVICING OF THE SYSTEM.
CAUTION: RECEIVER DRYER MUST BE REPLACED ANY TIME THE VCS PLUMBING IS OPENED FOR
MAINTENANCE. REFER TO DISASSEMBLY (SECTION 5) AND ASSEMBLY (SECTION 9).
8.2. Condenser Module Repair Procedures:
8.2.1. The following components may require periodic repair and/or replacement (refer to the
Inspection Schedule in Section 7 for mandatory time intervals) (refer to Figure 10001):
•
Receiver Dryer
•
Fan / Outlet Shroud
•
Condenser Coil
Copyright © 2020
Page | 30
REPAIRS
Original Release
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
www.enviro-ok.com
passenger
www.safran‐
ATA 21‐00‐60
‐solutions.com
Advertisement
Table of Contents
