Table of Contents
Advertisement
NOTE: Do not disassemble the parts unnecessarily.
5.1.7. Refer to Illustrated Parts Listing (IPL) for figure/item numbers (Section 11).
5.1.8. Tools, fixtures, equipment, or consumable items required:
•
Small hand tools and socket set
•
Scribe or wire hook
•
Volt or OHM meter (digital)
•
Shop air, 40 PSIG max
•
Respiration mask
5.2. Condenser Module Disassembly Procedures
5.2.1. Removal of Receiver Dryer
5.2.1.1.
5.2.1.2.
5.2.1.3.
5.2.1.4.
5.2.1.5.
5.2.1.6.
mounting bracket.
5.2.2. Removal of Hose Assembly
5.2.2.1.
may ease loosening of the nut. Take care not to damage surrounding components with
excessive heat.
5.2.2.2.
Copyright © 2020
Page | 22
Verify that system refrigerant charge has been recovered (refer to Servicing, Section
13)
Disconnect electrical wiring to binary pressure switch.
Disconnect refrigerant plumbing connection from receiver dryer inlet port.
Disconnect discharge refrigerant line from receiver dryer outlet port.
Cap receiver dryer (if reusing) and plumbing connections immediately.
Loosen receiver dryer attaching clamp and carefully slide receiver dryer from
The hose assembly has Loctite thread sealant applied. Slight heat using a heat gun
Use a backup wrench on the condenser outlet to ensure no damage to the welds occur.
Original Release
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
www.enviro-ok.com
passenger
www.safran‐
ATA 21‐00‐60
‐solutions.com
Advertisement
Table of Contents
