Porsche 911 Turbo 2014 Owner's Manual page 216

14_991_Turbo_21.book Seite 214 Mittwoch, 9. April 2014 2:19 14
6. The turn signal lights will flash once when the
5 minute teaching readiness period has
elapsed.
Repeat steps 3 to 5.
7. Repeat steps 3 to 5 to assign further signals
to the remaining buttons.
8. Locate the programming button on the
receiver of the equipment to be programmed,
e.g. on the motor unit of the garage door
opener.
Synchronizing the system
9. Activating the motor unit:
Press the programming button on the receiver
of the garage door opener.
You then usually have approx. 30 seconds to
initiate step 10 (a setting indicator is usually
activated on the motor unit).
10. Programming on the overhead operating
console:
Press the button you selected in step 3 three
times on the overhead operating console
keypad (you must press the button on the
keypad several times to complete the setting
process for some devices).
11. Repeat steps 3 to 10 to assign signals to the
other buttons.
12. After completing programming on the
overhead operating console, the system
should recognize the HomeLink
launch as soon as the memory button is
pressed when the ignition is switched on.
214
Parking
Reprogramming an individual button on the
keypad
®
A HomeLink
reprogrammed without deleting the rest of the
button assignments.
On the overhead operating console:
1. Switch on ignition.
2. Press and hold the button to be programmed
on the overhead operating console keypad
(approx. 20 seconds), until indicator light A on
button II flashes slowly.
You now have 5 minutes to teach the button.
3. Stand in front of the vehicle with the original
remote control of the system to be
programmed.
In front of the vehicle:
4. Hold the original remote control approx. 12 in.
(30 cm) away from the marked position
(illustration) and press and hold the transmit
button (for more than approx. 1 minute in
some cases) until the vehicle's turn signal
lights flash on and off three times or the
indicator light A in the overhead operating
console starts to flash quickly.
The turn signal lights flash three times and the
indicator light A flashes quickly to confirm that
the new signal has been programmed
successfully.
Several attempts with different distances
®
signal and
between the vehicle and the original remote
control may be necessary.
With some systems, the transmit button on the
original remote control may need to be
pressed again when the indicator light on the
original remote control goes out.
button can be individually
5. The turn signal lights will flash once when the
5-minute teaching readiness period has
elapsed.
Repeat steps 1 to 4.
6. Repeat steps 1 to 4 to assign further signals
to the other buttons.
Information
f
Please consult an authorized Porsche dealer if
you have not been able to successfully assign
signals to the buttons even though you have
carefully followed the instructions in this
section and the operating instructions for the
original remote control. Your authorized
Porsche dealer has a list of all garage door
opener signals that can be adapted.
f
Make sure that the battery in the remote
control for the garage door opener is new.
If the battery voltage is inadequate, faults may
occur in signal transmission. The system in the
vehicle then learns the wrong code, which will
not be recognized reliably by the garage door
opening mechanism.