Porsche 911 Turbo 2014 Owner's Manual page 204

14_991_Turbo_21.book Seite 202 Mittwoch, 9. April 2014 2:19 14
5. When fitting for the first time:
Remove the handle from the torque wrench.
Loosen screws on the underside of the
carriers using the short side of the torque
wrench.
Information
It is only necessary to loosen the screws on one
underside section of the relevant carrier.
202
Storage, Luggage Compartment and Roof Transport System
Place long carrier A at the front and short
carrier B at the rear on the rotary holders G
and, at the same time, adapt to the vehicle
width by means of the moveable carrier
supports.
Tighten the screws on the underside sections
of the carriers slightly.
Remove the carriers and retighten the screws
on the underside sections of the carriers using
the short side of the torque wrench.
6. Refit the handle of the torque wrench.