Kenmore 795.7102 Series Use & Care Manual page 37

NOT DISPENSING ICE
Check if...
All the doors are not closed completely.
The dispenser display is locked.
Ice is not selected on the dispenser.
The ice dispenser is not used often.
Ice bin is not installed correctly.
New installation.
Ice cubes are stuck in the delivery chute.
The ice dispenser is stalling while dispensing "crushed"
ice.
DISPENSING WARM WATER
Check if...
New installation.
The water dispenser has been recently used.
The refrigerator is connected to a hot water line.
All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE
Then...
Ice will not dispense if any of the refrigerator doors are left
open.
Press and hold the Lock (
control panel and dispenser.
The dispenser can be set for ice or water. Make certain that
the control panel is set for the proper operation. Press the
dispenser button on the control panel to cycle through the ice
and water options.
Infrequent use of the ice dispenser will cause the cubes to
stick together over time, which will prevent them from properly
dispensing. Check the ice bin for ice cubes clumping/sticking
together. If they are, break up the ice cubes to allow for proper
operation.
Be sure to install the ice bin firmly into position.
Wait 24 hours after icemaker installation for ice production to
begin. Wait 72 hours for full ice production.
Use a plastic utensil to clear the delivery chute.
Change the ice button from "crushed" to "cubed".
If cubed ice dispenses correctly, depress the button for
"crushed" ice and begin dispensing again.
Then...
Allow 24 hours after installation for the water supply to cool
completely.
The unit has its own water tank inside. The water storage
capacity is 12 oz. (345 ml) of cold water.
Make sure the refrigerator is connected to a cold water pipe.
37
) for 3 seconds to unlock the