Kenmore 795.7102 Series Use & Care Manual page 32

8. FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the
water is clear.
Shut the water off at the water
valve after about one quart of
water has been flushed through
the tubing.
9. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
1. Remove the plastic flexible cap from the water valve.
2. Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
3. lnsert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
w w CAUTION: Check to see if leaks occur at water line
connections.
Tubing Clamp
1/4 "
Compression
Nut
Ferrule
(sleeve)
w w CAUTION: Check to see if water dripping occurs at
water line connections.
All manuals and user guides at all-guides.com
CONNECTING THE WATER LINE
1/4 " Tubing
Refrigerator
Connection
32
10. TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the On (I) position.
NOTE: A newly installed refrigerator may take
several hours to start producing ice.