Advertisement
Cleaning the burner heads
To avoid possible burns, do not attempt cleaning
before turning off all surface burners and allowing
them to cool.
Any additions, changes, or conversions required in
order for this appliance to satisfactorily meet the
application needs must be made by an authorized
qualifi ed Agency. Routinely clean the cooktop.
Wipe with a clean, damp cloth and wipe dry to
avoid scratches. Keeping the surface burner head
ports and slots clean will prevent improper ignition
and an uneven fl ame.
To clean recessed and contoured areas of cooktop:
•
If a spill occurs on or in the recessed or con-
toured areas, blot up spill with an absorbent
cloth.
•
Rinse with a clean, damp cloth and wipe dry.
CAUTION
To avoid possible burns do not attempt to oper-
ate the surface burners without the burner caps.
Do not use spray oven cleaner on the cooktop.
To clean burner heads:
1.
Remove the burner cap and burner head (see
Figure 14). Clean the cap and head with hot
soapy water and dry thoroughly.
2. For burned-on and dried spills, apply hot soapy
water to the burner cap and head to allow time
for the soils to soften.
3. Use a toothbrush to clean all over the burner
head.
4. Wipe the burner cap and head clean with a
soft, clean cloth, sponge, or scratch-free clean-
ing pad. Wipe out burner orifi ce with a cloth
before placing burner head and cap back on.
The burner assembly must be completely dry
before use.
5. Make sure the burner caps and heads are
placed and seated properly over the ignitor.
The three mounting legs on burner will align
with slots on the orifi ce holder. When placed
correctly, the burner cap should not move off
the burner head (see "Assembly of the Burner
Caps" on page 9).
6. If burner fails to light, recheck placement of
burner head to the orifi ce holder and cap.
CARE AND CLEANING
Burner Cap
Burner Head
Orifi ce Holder
Ignitor
Figure 14: Removeable burner components
Important notes:
•
Always keep the surface burner caps in place
whenever a surface burner is in use.
•
When replacing the burner caps, be sure the
burner caps are seated fi rmly on top of the
burner heads.
•
For proper fl ow of gas and ignition of burners
do not allow spills, food, cleaning agents, or
any other material to enter the gas orifi ce port
opening.
17
Advertisement
