Iiyama PLE1700S Service Manual page 32

All manuals and user guides at all-guides.com
PLE1700S Service Manual
F. Adjust Color Temperature:
(1) EEPROM INIT(5BLOCKS):
Press "▼" key move cursor to EEPROM INIT, Press
INIT ADC value
(2) Press "▲" key move cursor to "White Balance", Press
adjustment.
(3) Press "▼" key move cursor to "Color Temerature Adjust", Press
OSD will display Fig.2
(The data on this picture is a example only,the real one,please refer to your monitor.)
(4) Cool verify: move cursor to Cool Press
Press "▼" ,"▲" key adjust R.G.B value
x=0.283 ±0.03
y=0.298 ±0.03
Press
1
(5) Normal verify: Repeat (4) press "▼" ,"▲" move cursor to Normal press
x=0.313 ±0.03
y=0.329 ±0.03
Y≥250 cd/m
(6) Warm verify: Repeat (4) press "▼" ,"▲" move cursor to Warm press
x=0.332 ±0.03
y=0.348 ±0.03
1
(7) Press key go back to Fig.2, Then press
OFF/ON quit factory mode.
G. Color Temperature & Luminance Verify:
BRIGHTNESS MAX, CONTRAST MAX
Cool: x=0.283 ±0.03
Normal: x=0.313 ±0.03 y=0.329 ±0.03 Y≥250 cd/m
Warm: x=0.332 ±0.03
2. Geometry:
(a). Set cross-hatch pattern and preset timing as timing table listed.
(b). Change to each mode in turn and wait for the monitor finish auto-alignment and save
process before change to next mode.
(c). Until all of modes are agjusted, exit OSD menu and press PWR OFF to exit factory
mode.
(Fig.2)
2 key,
key return to Fig.2
2
1 key return to Fig.1, Power key
y=0.298 ±0.03
y=0.348 ±0.03
-31-
2 key then monitor will
key do white balance
2
key, Then
2
key
2
key
2
2
05/12/2006