Hunter Illumi-Heat Installation Instructions Manual page 6

I N S TA L L AT I O N
8) Position the Glass Dome under the Heater/Light Fixture as shown in Figure 11a. Then,
place the Glass Dome over the Heater/Light Fixture as shown in Figure 11b.
Heater
Install Glass Dome
Figure 11a
9) Position the Finial over the Glass Dome as shown in Figure 12, and twist it clockwise until
tight.
Figure 12 - Install Finial
43533-01 05/28/2008
c o n t i n u e d
Glass Dome
Figure 11b
Glass
Finial
10
O P E R AT I O N
1) Restore power at the breaker.
2) Install the 12V alkaline battery (included) into the Transmitter.
3) Use the Heater On/Off buttons on the Transmitter to turn the Heater on and off. Use the
Light On/Off buttons to turn the light on and off. See Figure 13.
Heater Off
Light Off
Figure 13 - Transmitter Buttons
4) Mount the Transmitter Holder over the Illumi-Heat's wall switch using the the existing wall
plate screws. See Figure 14.
5) The Transmitter can be placed in the Transmitter Holder for convenience or safekeeping.
Figure 14 - Installing Transmitter Holder
Technical Support
If you have any additional questions or problems with your Illumi-Heat please call
1-888-830-1326 (in the United States) or 1-866-268-1936 (in Canada), or contact us over
the internet at www.hunterfan.com.
Heater On
HEATER
OFF ON
LIGHT
OFF ON
Light On
11 43533-01 05/28/2008