Hunter Illumi-Heat Owner's Manual
Heater fan
Hide thumbs
Also See for Illumi-Heat:
- Installation instructions manual (13 pages) ,
- Owners and installation manual (12 pages)
Related Manuals for Hunter Illumi-Heat
Summary of Contents for Hunter Illumi-Heat
- Page 1 Illumi-Heat Heater Fan O W N E R ’ S M A N U A L Heater Fan Installation Instructions READ AND SAVE THESE INSTRUCTIONS 43004-01 06/13/2007 43004-01 06/13/2007...
- Page 2 TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE FOLLOWING: • Be cautious! Read all instructions and safety information before installing your new heater fan. Carefully review the assembly illustrations. • Use this unit only in the manner intended. •...
- Page 3 PA R T S Hanger Bolts (2) Hanger Bracket Acorn Nuts (2) Heater/Light Fixture Light Sockets (2) Glass Dome Finial Tools Needed 43004-01 06/13/2007...
- Page 4 I N S TA L L AT I O N 1) If you are replacing an existing light fixture, disconnect and remove the old fixture and hang- er bracket, leaving the exposed wires coming from the electrical box. 2) Assemble the Hanger Bolts, Hanger Bracket, and Hanger Nuts as shown in Figure 1. NOTE: The Hanger Bracket holes are threaded and the Hanger Bolts must be screwed into them.
- Page 5 I N S TA L L AT I O N c o n t i n u e d 5) Position the Heater/Light Fixture so that that Hanger Bolts will mate with their associated holes in the Heater/Light Fixture. See Figure 3. NOTE: For clarity, the electrical box and wires have been omitted from this illustration.
- Page 6 I N S TA L L AT I O N c o n t i n u e d 7) Install two 60-watt B10 Candelabra light bulbs. 8) Position the Glass Dome under the Heater/Light Fixture as shown in Figure 5a. Then, place the Glass Dome over the Heater/Light Fixture as shown in Figure 5b.
- Page 7 O P E R AT I O N 1) Restore power at the breaker. 2) Place the wall switch in the On position. 3) Install an AAA battery into the Remote. 4) Use the Fan buttons on the remote to turn the Heater on and off. Use the Light buttons to turn the light on and off.