Hunter Illumi-Heat Installation Instructions Manual page 3

P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t
U n i t s i n Yo u r H o m e
If you are going to install more than one Illumi-Heat in your home, then you will need to assign
each unit a its own unique Transmitter / Receiver Code.
1) Looking at the fixture from its top, locate the Receiver, as shown in Figure 1.
(Bracket cut away
for clarity.)
Receiver
ON DIP
1 2 3 4
Figure 1 - Receiver
2) On the Receiver you will see the four switches that you will use to set the code for the
Transmitter and the Receiver. See Figure 2.
Switches
ON DIP
NOTE - All Switches are
shown in the ON position
1 2 3 4
Figure 2 - Receiver Code Switches
43533-01 05/28/2008
Top View of Fixture
ON DIP
1 2 3 4
4
P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t
U n i t s i n Yo u r H o m e
3) Configure the Receiver Switches to your desired code. Make a note of which Receiver
Switches you turned On and turned Off. NOTE: Make certain each Receiver is assigned a
different code.
4) Remove the Transmitter Battery Compartment door as shown in Figure 3.
Figure 3 - Remove Transmitter Battery Compartment Door
5) For every Receiver Code Switch you turned Off, use a pair of needle-nosed pliers to
carefully remove its corresponding Connector from the Transmitter Terminals. See Figure 4.
For instance, if you turned Off Receiver Switches 1 and 3, then you would remove
Connectors 1 and 3 from the Transmitter.
Transmitter Terminals
1 2 3 4
Connector
Figure 4 - Transmitter Terminals and Connector
Transmitter Battery
Compartment Door
5
43533-01 05/28/2008