Hunter Illumi-Heat Installation Instructions Manual page 4

I N S TA L L AT I O N
1) If you are replacing an existing light fixture, disconnect and remove the old fixture and
hanger bracket, leaving the exposed wires coming from the electrical box.
2) Attach the Hanger Bracket assembly to the electrical box as shown in Figure 5.
Electrical Box
Hanger Bracket
Figure 5 - Attach Hanger to Electrical Box
43533-01 05/28/2008
6
I N S TA L L AT I O N
3) Suspend the fixture by placing the Cable Loop over the Cable Loop Hanger. See Figure 6.
Figure 6 - Suspend the Fixture
4) Use UL-approved wire connectors to connect the wires, black-to-black, white-to-white. Loop
the ground wires around the Ground Screw, then tighten the Ground Screw. See Figure 7.
Ground Screw
Figure 7 - Ground Screw
c o n t i n u e d
Cable Loop Hanger
Cable Loop
7 43533-01 05/28/2008