Siemens SMART 7KT Manual page 11

Configuration
For reading serial number
Press F3 key for 5 sec. to display 8-digit serial number only for 5 sec. at 5th line of display
Automatic / manual mode
Press F4 key for 3 seconds to toggle between Automatic and Manual mode.
Note: By default, unit operates in automatic mode.
In automatic mode online pages scroll automatically at the rate of 5 seconds per page.
In automatic mode when any key is pressed, unit temporarily switches to manual mode and the appropriate page is
displayed. If any key is not pressed for 5 sec, unit resumes automatic mode.
Password to start configuration
When the meter is brought into the configuration mode by pressing keys F3+F4, the first page that is displayed is the
password page which shows the password 0000. Enter the password 1000 which is the default factor-set password
by pressing the F1 key to move curser left or right by one digit at a time and F2 or F3 keys for increasing or decreasing
parameter values. After you enter the password of 1000, press F4 key to go to the next page which is the password
change page and continue with parameterization.
For the configuration setting mode
Press F3 + F4 keys for 3 seconds to enter or exit from the Configuration menu.
Use F1 key to move curser left or right by one digit at a time
Use F2 or F3 keys for increasing or decreasing parameter values
Press F2+F4 key to go back to previous page
There are 4 dedicated keys labelled as F1, F2, F3, F4. Use these 4 keys to read meter
parameters. Simply press these keys to read the parameters.
The keys have multiple assignments. Function assignments and key labeling change
according to the context of operator input.
A short press on the key triggers the function once. Holding the key down for longer
switches on the autorepeat function after approximately 1 s. The function of the key is
triggered repeatedly while the key is held down. Autorepeat is useful, for example, for
fast incrementing of values when parameterizing the device.
SMART 7KT0310 Manual
6
11