Installing The Canopy And Canopy Trim; Ring - Hunter 7 Owner's Manual And Installation Manual

5 • Installing the Canopy and Canopy Trim Ring
5-1. Partially install two canopy screws (about 2 full turns) in the
hanger bracket.
5-2. Raise the canopy over the hanger bracket. Align partially installed
screws with key slots in canopy.
5-3. Twist canopy clockwise to secure.
5-4. Install third and fourth canopy screw in round hole on canopy.
Securely tighten all four screws.
5-5. Using both hands, push the canopy trim ring up to the top of the
canopy.
5-6. Twist canopy trim ring clockwise to secure the canopy.
Should you need to remove the canopy
trim ring, follow these steps:
1. Twist canopy trim ring
counterclockwise until it releases
from canopy.
Step 5-5
Canopy
Screw
10
45051-01 • 05/12/11 • Hunter Fan Company
Steps 5-1 – 5-2 Hanger Bracket
Canopy Trim
Canopy
Step 5-4

Ring

Step 5-3